[geofolk]

I have a similar problem except that everything is ok on the screen (font
size zoom, appearance in print preview, etc.) but it prints at about 2/3 the
size. This only happens on one of my documents. I have checked my printer
settings and they are the same for all documents. This document has been used
by myself and another person using "tracking" but once again this is the only
one that displays this behavior.

"Suzanne S. Barnhill" wrote:

What I don't understand is how changing the Zoom ratio could have no effect.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

"Lynne in DC" Lynne in wrote in message
...
I have the same problem. The selected font size in Word is 12 pt., but it
is
really tiny on my screen and I can hardly read it. I checked to see if
superscript or subscript was selected and it wasn't. I tried changing the
zoom percentage, but that did not change anything. When I print the
document,
the font appears normal at 12 pt. But on the screen, it's teensy. This
just
randomly started yesterday. Documents created before then are readable.
But
ever since yesterday, I can hardly read what I'm typing. Very frustrating.
I've looked at Microsoft Office Help and I haven't yet found anything that
addresses this particular problem.

"Suzanne S. Barnhill" wrote:

I suspect that your text has been formatted as Superscript. Select it and
press Ctrl+Spacebar. If that doesn't help, go to Format | Font and make
sure
Superscript isn't checked. If it is, clear the check box and then click
the
Default... button in the document and then OK to restore the
un-superscripted format as the default for new documents.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup
so
all may benefit.

"Paul in ABQ" Paul in wrote in message
...
My font sizes changed recently and I can't get them back to normal
size.
When I open a new document, the default is Times New Roman 12 pt.
However,
that's not what shows up on the screen. The font is tiny, more like 8
pt.,
although it is labeled as 12 pt. I am using print view, page width.
Worse
yet, the line spacing (set to single) seems to be at normal scale so
that
single spacing looks like double spacing and any effort to reduce by
setting
"exactly at" cuts off the portions of font below the line (e.g.,
jgypq).
Any
older documents created before this problem occurred look fine, that is
12
pt. font looks like 12 pt font (print view, page width). However,
anything
new suffers from this problem.