Sue, try unchecking "Heading rows repeat", reselect yr table header, and
check "Heading rows repeat" again. I don't know why but sometimes it
mriaculously solves the problem.
HTH - Henk
Sue D;2366086 Wrote:
I revealed hidden formatting codes and looked through three times for
section
or page breaks and did not see any. Table Properties shows only row 1
as the
header row. I'm not sure what you mean by not wrapped. If you mean
the
table is wider than the paper, I changed Table Properties to set the
table
width at 100% and still have the problem.
"Doug Robbins - Word MVP" wrote:
-
The following has previously been posted when that problem has come
up:
Make sure the table is not wrapped and has no breaks and that you
don't have
all the rows set as heading rows.
--
Hope this helps.
Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.
Doug Robbins - Word MVP
"Sue D" wrote in message
...-
I have a table with row 1 defined as a repeating header row. Table
Properties confirms the setting. However, the row does not repeat on
any
page. I cannot find a manual page break in the table. I have run a
repair
of the software. This table is 16 pages long so a header row is
desired. -
-
--
Henk57