Okay, I created the artwork that is required to satisfy
the requirements of the letterhead template. The header
section of the template is filled with a JPEG image. Then,
a frame was superimposed on the image allowing for easy
variations of text content in the letterhead. Everything looks
fine except that the header section required page margins
that really aren't desirable for the document body. E.g.,
the header section is 8 inches wide while that isn't normally
an appropriate column width for the body of the document.
Is there a way to have different margins for the header than
that of the body?
Thanks,
Bill
"Graham Mayor" wrote in message
...
http://sbarnhill.mvps.org/WordFAQs/Letterhead.htm
--
Graham Mayor - Word MVP
My web site www.gmayor.com
Word MVP web site http://word.mvps.org
Bill wrote:
If one desires to create letterhead stationary that
can be "typed into", how does one or what does
one create for such purposes? A template? What?
Our otherwise pre-printed letterhead has a logo
on the upper right-hand corner plus horizontal
and vertical lines parallel to and close to all four
edges of a 8.5" x 11" paper and our mailing
address immediately below the logo.
Thanks in advance for any suggestions,
Bill