Hi ?B?QWJiZXkgb2YgRmFyZmE=?=,
When I select the column in question and then click Accept Changes, Word
selects all the columns in the table. How do I get it to accept changes in
only the one column?
I don't think there is any way, short of programming a macro to accept the
changes cell-by-cell. The problem is that Word only recognizes a "contiguous
range" from left-to-right, top-to-bottom. The fact that Word lets you select
an entire column and format it is "magic". Unfortunately, not all Word
commands are linked into this "magic".
Cindy Meister
INTER-Solutions, Switzerland
http://homepage.swissonline.ch/cindymeister (last update Jun 17 2005)
http://www.word.mvps.org
This reply is posted in the Newsgroup; please post any follow question or
reply in the newsgroup and not by e-mail :-)