BTW, Stefan:

Is there any way to make rectangular cells (the default shape of a new
table) into square cells?


"Stefan Blom" wrote in message
...
You are welcome.

--
Stefan Blom
Microsoft Word MVP


"SF" wrote in message ...
Ah!
Dragging cannot be used for the entire table.
So that explains it.
Thanks, Stefan.


"Stefan Blom" wrote in message
...
When dragging, only the size of the selected column or cell(s) is
affected; there is no way around that.

The only way to preserve the relative widths of columns is to set
a
percentage width for the entire table (as explained in the
article).
To make the table fit between margins, set the table width to
100%; if
you want it smaller, use a value smaller than 100%.

--
Stefan Blom
Microsoft Word MVP


"SF" wrote in message
...
Windows XP
Word 2000

How can I increase or decrease the size of cells all in sync?
(Make the whole table proportionately larger or smaller?)

I went to the MVP page:

http://word.mvps.org/faqs/tblsfldsfm...ableToPage.htm
and followed these instructions:

In Word 2000 you can select Table + Properties, click on the
"preferred
width" checkbox; where it says "Measure in", change it to
"percent",
and in
the width spinbox, type 100%. The relative column widths are
preserved in
the resized table.

But dragging the last cell to the right still only changes the
size
of that
particular column of cells.