[Suzanne S. Barnhill]

So read the parts that pertain to Word 2007 and follow them.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"eman" wrote in message
...
I'm not stubborn and you are not helpful

"Suzanne S. Barnhill" wrote in message
...
Are you incapable of scrolling down past the first screen? The article at
http://www.gmayor.com/installing_macro.htm has several sections
specifically devoted to Word 2007. If you are too stubborn to find them,
then you're on your own.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"eman" wrote in message
...
Hi Suzanne, you are trying to be smart!!!!!!!!!! The link Graham
suggested is for 2000-2003.
And Suzanne I am not asking you but thanks anyway. What I need is how
can I use the document (or macro) that Graham posted?
Or I have to install Macro first? I am new to this and I am confused.

"Suzanne S. Barnhill" wrote in message
...
I guess it was a complete waste of time for Graham to include the parts
that say, "In Word 2007..."?

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"eman" wrote in message
...
It is for Word 2000-2003, I have Word 2007

"Suzanne S. Barnhill" wrote in message
...
Graham provided this information in his initial post:
http://www.gmayor.com/installing_macro.htm

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"eman" wrote in message
...
Hi, as I never used maros before, please can you tell me how can I
make use of it?

10X

"Graham Mayor" wrote in message
...
Testing the macro on the 125 pages of subtitles from 'The Godfather
III', the macro takes just over a minute to run through and mark
the whole document. In doing so I came up with a minor refinement
which will allow you to re-mark the document by running the macro
again with a different value for the number of lines. Setting the
value to 1 will remove the highlight, though there are much faster
ways to remove the highlight e.g.

Sub RemoveTheHighlight()
ActiveDocument.Range.HighlightColorIndex = wdAuto
End Sub

Revised macro:

Sub HiLightFive()
Dim oRng As Range
Dim oTest As Range
Dim i As Long
Dim iPara As Integer
iPara = InputBox("Highlight how many lines?", _
"Subtitle", 5)
Selection.HomeKey wdStory
Set oRng = ActiveDocument.Paragraphs(1).Range
For i = 1 To ActiveDocument.Paragraphs.Count
Selection.MoveDown wdLine
Set oTest = Selection.Paragraphs(1).Range
If Len(oTest) = 1 Then
oRng.End = oTest.Start
If oRng.Paragraphs.Count = iPara Then
oRng.HighlightColorIndex = wdYellow
Else
oRng.HighlightColorIndex = wdAuto
End If
oRng.Start = oTest.End
End If
Next i
End Sub


--

Graham Mayor - Word MVP

My web site www.gmayor.com
Word MVP web site http://word.mvps.org



Graham Mayor wrote:
Assuming that when imported into Word each line ends with a
paragraph
mark, and there is an empty paragraph between each 'verse' then
the
following macro will highlight all the sections with 5 or more
paragraphs in yellow.
Sub HiLightFive()
Dim oRng As Range
Dim oTest As Range
Dim i As Long
Selection.HomeKey wdStory
Set oRng = ActiveDocument.Paragraphs(1).Range
For i = 1 To ActiveDocument.Paragraphs.Count
Selection.MoveDown wdLine
Set oTest = Selection.Paragraphs(1).Range
If Len(oTest) = 1 Then
oRng.End = oTest.Start
If oRng.Paragraphs.Count 4 Then
oRng.HighlightColorIndex = wdYellow
End If
oRng.Start = oTest.End
End If
Next i
End Sub

http://www.gmayor.com/installing_macro.htm



eman wrote:
Hi,

Here under the line you can see a small part of subtitles of a
movie.
As you can see there are paragraphs of 3, 4 and 5 short verses.
For
example 1st paragraph is with 3 verses, 2nd is with 4 verse and
the
5th is with 5 verses.

The 3rd paragraph is with 5 verses and it is wrong (for me). I
want
only paragraphs with 3 and 4 verses.

What I am looking for is, if it is possible that Words can mark
automatically paragraphs with 5 verses for example with a color
instead of checking manually all the document, because subtitles
of a
movie are very long!

Maybe it's impossible but I am just asking.

I always remember of Google highlighter, it is very usefull when
you
are searching for a word because you can see the word colored
easily.
Maybe there is something similar in Word.

Thanks in advance

__________________________________________________ ___

574
00:29:55,960 -- 00:29:58,087
I know. I have no idea.

575
00:29:58,163 -- 00:30:00,996
It's, like, the wrong time to let
the guy know that you're crazy.

576
00:30:01,065 -- 00:30:03,533
- You know what I mean? It's not how
I'd play it.
- Yeah.