[Jezebel]

Simply drag the margin markers on the ruler, when the header is selected; or
go to Format Paragraph and set the left and right indents explicitly.



"Bill" wrote in message
link.net...
Hi Suzanne,

I'd already read your URL, but I don't see how to, as you say,
"Just give the header paragraph negative right and left indents."
As I have it now, the left and right boundaries of the header section
are dictated by whatever is set for the document. In order to
achieve the proper size in the header section in which fits an 8 inch
wide JPEG image, I have to set the page margins to .25 inches
left and right.

I don't see any handles on the header that would allow me to
increase its width beyond the page boundaries.

The only "paragraph" in the header is text that is centered in
a borderless frame superimposed on the image.

Can you explain a bit further for me?

Thanks,
Bill


"Suzanne S. Barnhill" wrote in message
...
Absolutely. In this case you're talking about the side margins, right?
Just
give the header paragraph negative right and left indents in the required
amounts. You can do different top margins, too; see
http://sbarnhill.mvps.org/WordFAQs/Letterhead.htm

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup
so
all may benefit.

"Bill" wrote in message
hlink.net...
Okay, I created the artwork that is required to satisfy
the requirements of the letterhead template. The header
section of the template is filled with a JPEG image. Then,
a frame was superimposed on the image allowing for easy
variations of text content in the letterhead. Everything looks
fine except that the header section required page margins
that really aren't desirable for the document body. E.g.,
the header section is 8 inches wide while that isn't normally
an appropriate column width for the body of the document.
Is there a way to have different margins for the header than
that of the body?

Thanks,
Bill

"Graham Mayor" wrote in message
...
http://sbarnhill.mvps.org/WordFAQs/Letterhead.htm

--

Graham Mayor - Word MVP

My web site www.gmayor.com
Word MVP web site http://word.mvps.org


Bill wrote:
If one desires to create letterhead stationary that
can be "typed into", how does one or what does
one create for such purposes? A template? What?

Our otherwise pre-printed letterhead has a logo
on the upper right-hand corner plus horizontal
and vertical lines parallel to and close to all four
edges of a 8.5" x 11" paper and our mailing
address immediately below the logo.

Thanks in advance for any suggestions,
Bill