[Richard[_2_]]

"Richard" wrote in message
...
Sometimes the end of a chapter (say) ends on the obverse, which is
probably (but not exclusively) an odd page number. The next chapter starts
on the next even number, and, if you are printing duplex, the first page
of the new chapter is printed on the back of the page - that is, it gets
printed on the reverse of the page.

Now of course you can have a blank page after the end of the chapter, and
that will ensure that the next chaper is printed on the obverse, that is
the next chapter starts on the obverse, rather than the reverse. But, you
would not want the page numbering to change.

I'm doing duplex printing: Is there a way to get the page that would
normally print on the reverse, to print on the obverse, and a way not
avoid alteration in the page numbering? So start of (say) chapter 2 had
the same page number as originally.

TIA.

I have page 41 which is end of a hapter. Then there is "section break (Next
Page), then after that starts page 42. Page 42 is printing on the back of
page 41, because I'm running duplex printing.

Something here has to change, we don't want page 42 to print on the back of
page 41, but on a the next clean sheet. I don't know what break to put in.