On the Table tab of Table Properties, there is a width setting for the
entire table. This can be set in absolute inches (or other measurement) or
in relative percent.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org
"John Theo" wrote in message
...
Thanks Suzanne. I put the table in and it worked OK on the portrait pages
but didn't expand to fill the landscape ones. How do I set to "100%
width" ?
I can only see "fit to contents" and "fit to window" - but may not be
looking in the right place!
"Suzanne S. Barnhill" wrote:
One way to do this is with a table (three columns) set to 100% width. But
you will find that this is very processor-intensive and may make your
headers "shimmy" constantly as Word continually recalculates the width.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org
"John Theo" John wrote in message
...
How do I set up footers with left, centre and right aligned elements so
that
if I introduce a landscape section in a portrait document it still
works?