Bullet Point in a Mailmerge field
I think I found a suitable symbol, and it looks pretty good. I'm still
getting a blank line where the skipped record is. Is there any way around
that?? I'm getting.
Line 1
Line 2
Line 4
and what I would like is:
Line 1
Line 2
Line 4
Thanks again for your assistance!!
-Jer
"Doug Robbins - Word MVP" wrote:
Instead of using a bullet (as in numbering and bullets) use the symbol from
the InsertSymbol dialog
{ IF {MERGEFIELD Num_Purchased }0 "[Symbol here][tab]{MERGEFIELD
Num_Purchased}" ""}
--
Hope this helps.
Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.
Doug Robbins - Word MVP
"JerD@FSC" wrote in message
...
Hello all,
I am merging from an Excel worksheet into a Word doc. I am using
if...then...else to only give me data that exists. If that data exists, I
would like it to begin with a bullett. If I put the bullet in the word
doc,
then the bullet is always there....even if there is no merged data. What
I
would like to see is a bullet only if there is merge data but I don't know
how to put that into my merge statement. I'm using:
{ IF {MERGEFIELD Num_Purchased }0 "{MERGEFIELD Num_Purchased}" ""} {IF
{MERGEFIELD Num_Purchased} ="YES" "text about what was purchased" ""}
the reads something like:
5 3800 scanners purchased
I would like it to read:
(BULLET) 5 3800 scanners purchased
Any help would be WONDERFUL!! Thanks so much and I hope everyone had
great
holidays!!
-Jer
|