Is there some way to center section 2, then center section 1 and3?
On Oct 27, 1:49*am, "Terry Farrell" wrote:
Divide the page height (top margin to bottom margin) into three and create a
three row table with each row set to exactly the result. Set each table cell
to centre the contents.
If the middle row needs to be bigger to accommodate the contents, then
reduce the top and bottom row by half the amount you need to expand the
centre row.
--
Terry Farrell - MSWord MVP
"Robert Macy" wrote in message
...
On Oct 26, 2:31 pm, "Suzanne S. Barnhill" wrote:
You could make three (unbordered) table rows, with exact row height, and
vertically center the content of each.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USAhttp://word.mvps.org
"Robert Macy" wrote in message
....
Picture a top block of text lines, Section 1
Long body of text lines, Section 2
Trailing text lines of information, Section 3
How do I center Section 2 on the page vertically, then center Section
1 in remaining top space and Section 3 in remaining bottom space?
Is there a way to do this easily?
Thank you for your reply.
Would this center Section 2 on the whole page, followed by centering
Section 1 in what's left at the top and centering Section 3 in what's
left at the bottom?
Thank you. I will start experimenting.
But, so far letting the computer vertically center the text has not
been very acceptable. Way off.
So may have to stick with manual centering.
Robert
|