[clc2]

Thanks, Suzanne. What finally worked was going to the "Page Setup" tab in
the "Canon MP610 series Printing Preferences" window, then choosing
"Long-side stapling (Left) below the checked duplex printing box. So Canon
would seem to have moved from the original idea of "fliping on the long edge"
to "Stapling on the long edge."

Office almost always provides a way, but it's not always obvious to the user
who only gets to some of the features occasionally. I never found it in the
knowledge base or in "Help."

Best regards,

Chuck

"Suzanne S. Barnhill" wrote:

You'll need to check the duplex settings in your printer Properties. There's
usually a choice of whether to "flip" on the long or short edge. In this
case, you need to flip on the short edge.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

"clc2" wrote in message
...
I've created a nice looking two-sided tri-fold brochure, but when I print
it
in duplex mode on my printer, one side of the page prints "upside down."
That is, when the print is right side up on one side, it's reversed on the
other.

How do I fix this?