You are not selecting the table but its contents. Turn on the ShowAll
command so that you can see the paragraph marks. Look for the paragraph mark
at the end of the table: that is the important mark because that is the
table properties. Now select the Table including the paragraph mark. Then
nudge.
But this is all wrong. The labels created from the labels wizard should
print correctly. You are letting the tail wag the dog - the tail being the
printer.
--
Terry Farrell - MSWord MVP
"Frank Martin" wrote in message
...
I tried this but all it does is move the table contents down, whereas I
want them up. Putting a negative number into the field does not work.
Frank
"Suzanne S. Barnhill" wrote in message
...
You can use Spacing Before.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org
"Frank Martin" wrote in message
...
It made no difference.
I have compensated in the horizontal direction by using the
Format/Paragraph/Indents&Spacing/Indents, and when I select the whole
table (8 labels) they move en masse to the left by the selected amount.
Is there something similar for the vertical?
It looks like I have to redo all the labels for a printer and keep them
in a folder for that printer.
Regards, Frank
"Terry Farrell" wrote in message
...
What happened when you started Word in Safe Mode: did it still print
misaligned?
Terry
"Frank Martin" wrote in message
...
Thanks, I downloaded the latest driver (Jan 10) and this help a bit.
However the problem no is that there is displacement of the labels
down the page, that is there is too great a margin at the top of the
page and this cannot be varied with any printer settings.
Has Word2003 any way of adjusting this, which would mean compensating
for the printer's inability to grab the paper at the very top edge?
Frank
"Terry Farrell" wrote in message
...
That should not be necessary. The defined labels should work with any
printer: if they don't, then either you have change normal.dot or the
printer driver is incompatible. To test if it is a normal.dot or
incompatible add-in rather than the printer, start Word in Safe Mode
and test print a sheet of labels.
From Start | Run (Winkey+R), type in
winword /a
and press Enter. Word will start in Safe Mode bypassing all
customisations and add-ins. Open a sheet of labels and print now. If
they are still misaligned, then you have a bad printer or printer
driver.
--
Terry Farrell - MSWord MVP
"Frank Martin" wrote in message
...
I have labels on an A4 sheet, and because we have a new printer it
is necessary to fine tune the position of these.
It is hard to use the mouse for fine tuning and I wonder if there is
a 'nudge' using just the keyboard for very fine tuning.
(I already know about suppressing the "snap to" by pressing down the
'alt' key.)
Frank