Thanks. I was hoping to find a way to avoid using columns and section
breaks.
--
AMA
"Doug Robbins" wrote:
If you were to use a single column table in a three column layout, you could
get the numbering to go down column 1, THEN COLUMN 2 and finally column 3.
If you don't want column 2 numbered, then select the cells in that column
and remove the numbering from them and column 3 will then carry on from
column 1
--
Hope this helps.
Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.
Doug Robbins - Word MVP
"AMA" wrote in message
...
Is it possible to create a table and have the numbering go down column 1
and
then continue in column 3? When I tried it, it numbers go across not up
and
down.
Thanks,
--
AMA
|