I don't know what the horizontal position problem is, and it might
point in a different direction, but this is worth a try...

The vertical shrinkage is sometimes a symptom of drying or clogging of
the rubber rollers that push the paper through the printer. The label
stock is thicker and often a little more slippery than ordinary paper.
If the rollers lose some of their friction with age, they tend to slip
a little, and this is more prevalent and more noticeable on labels.

You can try using a soft pencil eraser to rough up the rollers (if you
can reach them). It probably isn't cost-effective to get the rollers
replaced.

--
Regards,
Jay Freedman
Microsoft Word MVP FAQ: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the
newsgroup so all may benefit.

On Fri, 2 Jun 2006 19:27:21 -0400, "Guy Delaney"
wrote:

Tracked Changes is turned off. The labels look fine when I go to Print
Preview, but when I print, the labels print with equal margins on the rigth
and left (amnost as if the labels are centered horizontally). The first row
of labels seem to print with the correct Top Margin, but after that, each
label looses a little more of the vertical alignment with each row, leaving
about a 4" margin at the bottom. The type seems to be 8 maybe nine point,
but certainly not 12 point.

Guy


"Suzanne S. Barnhill" wrote in message
...
Are the labels printing high and to the left? If this were any other
document, I would suspect that it contained Tracked Changes or Comments.
Be
sure that Track Changes is not turned on when you create the labels.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup
so
all may benefit.

"Guy Delaney" wrote in message
...
I am using Microsoft Word 2003, and I am trying to print a page of labels
using the Avery Address Labels 5160. When I print the labels, they are
not
properly spaced. There are ten rows of labels, as there should be, but
they
do not conform to the Avery Labels 5160, that is, they print reduced in
type
size and in label spacing.

What do I need to do in order to get the labels to print in 12 point type
and to be spaced so that they print on every label?