[mshurk]

Thanks, Suzann. I tried, and curiously enough it's "fix" for the bottom
margin is .56". I find that strange. Is the problem my printer (a very
conventional HP 6110)?

"Suzanne S. Barnhill" wrote:

I agree that half an inch should be adequate for most printers. In Page
Setup, set all your margins to 0" and click OK. You'll get a message that
the margins are outside the printable area and an offer to fix them. Accept
the offer and note what margins result; those will be the default minimums.
You can then cancel out of the dialog without actually changing them. If the
bottom margin is actually more than 0.5", you can decide how to proceed from
there.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

"mshurk" wrote in message
...
.5"


This has worked on my documents in the past.

"Suzanne S. Barnhill" wrote:

What is your footer (not bottom) margin?

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

"mshurk" wrote in message
...
Since about six months ago I've been getting error messages telling me
that
each section (I don't use sections!) footer (I don't have footers other
than
page numbers!) goes beyond the printable page. I get these everytime I
try
to
print a document. I've checked the margin sizes and everything and as
far
as
I can tell nothing's changed. Any ideas?