AFAIR, the footer has been displayed this way in all previous versions of
Word, but perhaps I'm remembering incorrectly. I'm sure someone who has an
earlier version can tell us.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.

"Prince - Royal Realm" wrote in
message ...
Dear Suzanne ,
Thanks for your very prompt reply - I haven't progressed to the stage of
printing a document with footer because I had noticed , as you correctly
point out , on screen the footer pane is not represented as it should be
(now
using Word 2003 - whereas in earlier versions of Word this footer
misrepresentation didn't occur) .
Thus I had added text and indeed seen the top edge of the footer move up -
simply didn't know that Word 2003 has this display design flaw - I was
really
focussed on the header and footer panes being represented the same , first
on
screen as I always work in print view modus .
Thanks Again ,
Prince - Royal Realm


"Suzanne S. Barnhill" wrote:

Is this what you are actually getting in print or just what you are
seeing
on the screen? The header and footer panes are represented differently
in
Word. I'm not defending this, just stating a fact: the footer pane
(judging
from the broken lines) does appear to extend to the bottom of the page,
but
you will find that if you add lines of text, it will grow upward, not
down.
This is just a display design flaw.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the
newsgroup so
all may benefit.

"Prince - Royal Realm" Prince - Royal
wrote in message
...
Friendly Greetings To The Community ,
All my settings in Word 2003 (re. page setup etc) are correct ,
however
Word
fights me to accept " the distance from the bottom edge of the paper
to
the
bottom edge of the footer ".
Bottom TEXT margin is set at 20 mm thus leaving me with 20 mm between
the
bottom of my last line and the bottom of the page ; within this margin
of
20
mm I would like to set the distance from the bottom edge of the footer
to
the
bottom edge of the page at 10 mm - thus I should have a margin of 10
mm
between the bottom edge of the page and the bottom edge of my footer.
This would give me a total footer height of about 10 mm as well ,
which is
now proving to be troublesome to achieve - I use the same settings for
the
header without any problem whatsoever.
The bottom edge of the footer is now flush with the bottom edge of the
page
and the total height of the footer is about 15 mm as well - not what I
want.
Again I must also repeat that my page settings and margins are
absolutely
correct.
Thanking You In Advance For Your Response(s),
Prince , Of The Coming Royal Realm