Okay, sorry for the unwarranted assumption of cluelessness. g FWIW, I find
the "Book fold" feature generally unsatisfactory. Not only does it reverse
"Mirror margins" but it is very unpredictable when you try to print specific
pages. That's why I'm still using the manual method described at
http://word.mvps.org/FAQs/Formatting...etPrinting.htm

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.

"Joan" wrote in message
...
Thanks for replying Suzanne. I should have been more clear. I selected
12
or sometimes all in the # of pages section. I only meant to point out
there
were 9 pages of text in the booklet and I am only getting one blank page
when
I print. Also my other booklet is 32 pages and I again am only getting
one
page printing and that is from the middle of the book.

"Suzanne S. Barnhill" wrote:

There's no such thing as a "9 page booklet." Booklet pages have to be in
multiples of 4. If you go beyond 8 pages, you need to add 4 more (total
of
12); you will have 3 blank pages at the end.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the
newsgroup so
all may benefit.

"Joan" wrote in message
...
I am using Microsoft Word 2003 and I created and printed a booklet
successfully. The problem came when I added a few pages in the middle
and
tried to print again. Suddenly I only get one page out of a 32 page
booklet
and it's just actually a half of a horizontal 8.5" * 11". I also sent
the
booklet to a partner in this project for her to enter new information
for
an
additional booklet we are doing. The problem I have when I try to
print
hers
is that one piece of paper prints with nothing on it (a 9 page
booklet).
With both of these situations I see the entire booklet set up
perfectly in
my
print preview. I have tried everything: recopying original document
into
a
new booklet format and same problems. Any ideas?