|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
I was just experimenting with Word 2002's watermark function
printing to an HP Laserjet 1020.
On screen, I inserted a diagonal "DRAFT" and then printed a
It was the right size, color, and position, but appeared as
"DR F " rather then "DRAFT." (That is, dropping the "A" and
Next, I created a new doc, and tried again using the text
In both cases, all looked fine in Print Preview.
It printed as "A A " (That is, dropping the "S" and the "P."
My next step was to try a different printer, and HP Color
Again, all looked fine on screen and with Print Preview, but
when I printed "DRAFT" it appeared as "DRAFT"
^ ^ ^
where the "D", "A", and "T" were in a pale green, and the
"R" and "F" were in pale gray as they should be.
When I tried "ASAP" it printed as "ASAP"
where the "S" was pale green, and the other three letters
were in the pale gray.
What might be the cause of these odd problems?
If you email... Please remove the "SPAMLESS."
|Thread||Thread Starter||Forum||Replies||Last Post|
|Windows Update weirdness||Venture||New Users||4||September 26th 07 05:29 PM|
|Mail merge weirdness||[email protected]||Microsoft Word Help||1||June 19th 07 02:55 PM|
|Mail merge weirdness||Mark Tangard||Microsoft Word Help||1||May 30th 07 03:52 PM|
|document recovery weirdness||Pamlwell||Microsoft Word Help||4||June 19th 06 07:16 AM|
|High-Lighting Text weirdness||Chad Catlett||New Users||1||April 2nd 05 10:16 AM|