Reply
 
Thread Tools Display Modes
  #1   Report Post  
Posted to microsoft.public.word.docmanagement
Mischief Boy Mischief Boy is offline
external usenet poster
 
Posts: 1
Default Font size: smaller than size, then shifts to normal size ...

Font Size is the area I am stuck on. I have actually never seen this happen
before.
Word document ... Started with a title, underlined and bold, font size = 12.

Followed the title with a bullet. Started typing, and saw that the actual
size of the words were very, very small, in contrast to what the actual font
size was, shown up on the toolbar. Without any warning, as I continued to
type, the actual size increased to match the "12" size font (the way it is
supposed to). The only thing this reminds me of is that when I have typed in
a fraction (1/2 ... or 1/4, etc.) those characters change to a smaller size
(again, regardless of the font size shown in tool bar). However, the font
size returns to the correct size immediately. But in this case, I cannot get
it to change from the smaller size. Can someone help me with this?
Extremely irritating!
  #2   Report Post  
Posted to microsoft.public.word.docmanagement
Suzanne S. Barnhill Suzanne S. Barnhill is offline
external usenet poster
 
Posts: 33,624
Default Font size: smaller than size, then shifts to normal size ...

Well, assuming the issue is not your Zoom ratio, select the text and press
Ctrl+Spacebar. If you have inadvertently applied the superscript or
subscript font property, that will remove it.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"Mischief Boy" Mischief wrote in message
...
Font Size is the area I am stuck on. I have actually never seen this
happen
before.
Word document ... Started with a title, underlined and bold, font size =
12.

Followed the title with a bullet. Started typing, and saw that the actual
size of the words were very, very small, in contrast to what the actual
font
size was, shown up on the toolbar. Without any warning, as I continued to
type, the actual size increased to match the "12" size font (the way it is
supposed to). The only thing this reminds me of is that when I have typed
in
a fraction (1/2 ... or 1/4, etc.) those characters change to a smaller
size
(again, regardless of the font size shown in tool bar). However, the font
size returns to the correct size immediately. But in this case, I cannot
get
it to change from the smaller size. Can someone help me with this?
Extremely irritating!


Reply
Thread Tools
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Font size of footer changes from size set in normal template Islay Trainer Microsoft Word Help 1 September 3rd 07 01:18 PM
The lettering or font size prints smaller than the selected size o kalabjim Microsoft Word Help 1 October 19th 06 05:01 AM
First bullet is smaller, but all same size font?? Debby Microsoft Word Help 2 September 29th 06 08:28 PM
Cannot get font size smaller than 24 Still I am learning Microsoft Word Help 1 November 18th 05 02:55 AM
I want to reduce the font to a size smaller than 8..how do I do t. Laura Microsoft Word Help 2 November 24th 04 12:27 AM


All times are GMT +1. The time now is 01:10 PM.

Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 Microsoft Office Word Forum - WordBanter.
The comments are property of their posters.
 

About Us

"It's about Microsoft Word"