Is there a template for DIY daytimer pages? 3 3/4 x 6 3/4. 6 hole

Michelle -

I don't believe that there is, however you could create one
yourself with not too much trouble. A couple of questions. Will
your printer print on paper that size? Or are you going to cut
down a regular size piece of paper?

If you are going to cut down a regular size piece of paper, then
you may want to look at setting up a table to type your
information in. I find the easiest is to setup the table so that
it is two cells wide. I would set the two cells to be 3.75" wide
with internal left margins to support the 3 hole punch.. I would
set the height of your rows to be 6.75" high again with internal
margins to support where you want to start typing on the page.

If you are planning on printing a date on each page, and a
subject on each page or have a set layout like that, then add
form fields in the proper places and protect the document so that
they don't float around on a page. I did a cookbook just like
this only my pages were 6.5 x 8.5 so that all I had to do was cut
an 8.5 x 11 sheet of paper in half.

I hope that gives you an idea of how to get started.
Here are some web pages which may help as well:
http://word.mvps.org/faqs/formatting/Print2Pages.htm
http://www.computorcompanion.com/LPMArticle.asp?ID=22
http://www.computorcompanion.com/LPMArticle.asp?ID=46
http://www.computorcompanion.com/LPMArticle.asp?ID=119
http://www.computorcompanion.com/LPMArticle.asp?ID=127
&
http://word.mvps.org/FAQs/Customizat...platePart1.htm
http://word.mvps.org/FAQs/Customizat...platePart2.htm
(includes how to setup paper sizes)

Good Luck and write back if you get stuck.

--
Dawn Crosier
Microsoft MVP
"Education Lasts a Lifetime"

This message is posted to a newsgroup. Please post replies and
questions to the newsgroup so that others can learn as well.

"Michelle" wrote in message
...
Is there a template for DIY daytimer pages? 3 3/4 x 6 3/4. 6 hole