[Rae Drysdale]

On the extreme left of the ruler you should see what looks like a capital L.
When you click this it changes through an upside down T and a backward L.
Keep clicking until you see an upside down T with a dot beside it - the
decimal tab. Select the column or part of a column that you align figures. On
the ruler click the tab at the point where the decimal point would be on the
largest figure. All figures will align at this point. By the way, if you
click at the right of whole numbers they will also align as if there was a
decimal there. If you don't get it right first time you can drag the tab to
the correct place. Be careful not to click again and set more than one tab.
If you do, just grab it and drag it off the ruler to delete it. Hope this
helps.
--
Rae Drysdale


"Terry" wrote:

What is that? How to select it.
Will that work in only few columns and partial column?

I am using Word 2000.

"Jezebel" wrote:

Use decimal tabs.