Thread: How do I constrain a line to 30 degrees?
View Single Post
  #1   Report Post  
yetoyeto yetoyeto is offline
Junior Member
  
Posts: 0
Default How do I constrain a line to 30 degrees?
I have Office 2010 Pro. Is it possible to constrain a shapes/line to 30 degrees? I thought by holding shift this would work but that only changes the length of the line. Also, when drawing the line I see it will constrain to 45 degrees. Is it possible to change the 45 degrees to 30 degrees?

Thanks,
yetoyeto
Reply With QuoteReply With Quote