I think it's easier on Word and on you if you assign levels logically.
Obviously, your parts are a larger division than your chapters, so set them
up as Level 1 (and I would advise using Heading 1 for this purpose). Set
chapters as Heading 2/Level 2, but *don't* check the box for "Restart
numbering after Level 1." Use Heading 3 for the appendixes. For the rest,
use Heading styles or not as you choose; in any case, since they are not
numbered, they don't need to be part of your outline numbering scheme. For
the Introduction, I would be inclined to use a non-Heading style formatted
to be identical to Heading 2, including the Level 2 outline level, but
without numbering. The advantage of basing the style on Heading 2 is that it
automatically has an outline level, and the outline level is what determines
which paragraphs are picked up by your TOC. You can add an outline level to
any style, of course.
Given your present setup, however, what happens if you select your headings
and press Ctrl+Q? Does the numbering correct itself? Remember that whenever
you need to tweak the numbering, you must go in through the Level 1 style
(Chapter in this instance), and make sure that the numbering is set to start
at 1.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site:
http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.
"Paul Terrano" wrote in message
...
Win2000:Word2000
I am a simple person, with simple desires. I want the headings in
a book to look like the following. This is a different book and
arrangement then that discussed in an earlier thread several days
ago. I have followed Shauna Kelly's "How to create heading
numbering and outline numbering in Microsoft Word" To test the
formatting, I created a document containing only the lines shown
below and formatted the styles as described. I went through this
exercise twice with the same results.
Introduction
Part I: Menus
Chapter 1: Menu One
Chapter 2: Menu Two
Part II: Wizards
Chapter 3: Wizard One
Chapter 4: Wizard Two
Part III Appendices
Appendix A - Installation
Appendix B - Variables
Part, Chapter and Appendix are numbered headings as I understand
the term. There are un-numbered heading styles in both the
Chapters and Appendixes. The numbering is simple, in that there
is no requirement for paragraphs 2-3 or 4.1.3 or such.
Heading 1 is Chapter, at level 1, numbered in Arabic
Heading 2 is Part, at level 2, numbered in Roman
Heading 3 is Appendix, at level 3, numbered A, B, .
Headings 4-6 are additional chapter sub-heading styles, not
numbered
Headings 7-8 are additional appendix sub-heading styles, not
numbered
Heading 9 is for the Introduction, not numbered
The Chapter style insists on beginning with 2. The next two begin
with II and B, notwithstanding that in the lower right box in the
Numbering window they show 1, I and A. In the Customize Outline
Numbered List panel, the Number Format for level 1 is "Chapter 1:
". Levels 2 and 3 are similar. In the Preview window, all the
levels show as I would expect them to. Legal style numbering is
not checked and Restart numbering is not checked for any level.
The ListNum is named Book1.
The numbering difficulty may stem from my not understanding the
role of level. The docs say
Assign an outline level to a paragraph
Use outline levels when you don't want to change the appearance
of your text (the built-in heading styles apply specific
formatting, while the outline levels apply an "invisible"
format).
Am I a victim of invisible formatting or should I be restarting
something?