If your table is extending below the bottom margin, then I assure you it is
wrapped. Go to the Table tab of Table | Properties and select None for "Text
wrapping." If this is an older version of Word (pre-Word 2000), then a
wrapped table will be represented as being in a frame, and you will need to
remove the frame.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site:
http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.
"srj" wrote in message
...
Thanks for your reply. Unfortunately it didn't address the problem. I
tried
formating the paragraphs on the page, but it had no effect. Besides the
whole cell is in bulleted form so it should have allowed breaks before. I
still have 26 line below the page break. I don't know how to address the
problem. Thanks for your help.
"Doug Robbins - Word MVP" wrote:
How about the formatting of the paragraphs in the cell. Are they all
formatted to be kept with next?
--
Hope this helps.
Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.
Doug Robbins - Word MVP
"srj" wrote in message
...
The cell runs off the page because it is bigger than the page. The
table
is
only breaking between cell not in the middle. In cell properties,
allow
breaks is enabled. Document is a mess. It may be related to the
font. I
am
using an Arial font that's set up for Japanese. I'm reaching.
Your help is appreciated.