I'm having this problem with a landscape document with a table. I'm unable
to get the header rows to repeat and the header is larger than it should be.
I've checked the page setup on all the pages and the vertical alignment is
set to Top. The header is so large that it is just above the footer. Is
there anything else that can be done to fix this?

Ellen

"Suzanne S. Barnhill" wrote:

If you can see this question, I suspect you can see answers as well. In one
of the sections with a problem header, go to the Layout tab of Page Setup
and make sure that the vertical alignment is set to Top and not Center.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.

"angie" wrote in message
...
I also have this EXACT same problem and have been trying to find an answer
for hours. I have a 60-some page document that I added a header but have
about 10 pages where the header is 3x bigger than the others. I also
tried
changing it with the ruler and got the same result as you. Any help would
be
wonderful.



"Laurie" wrote:

In three non-consecutive pages of a 26 page document the header fields
are
nearly 3x the size of those headers on the remaining pages, i would like
them
to all be the same uniform size, however when attempting to drag the
ruler
marker while viewing headers and footers the tabs only jump larger and
when
trying to be made smaller will fill nearly the whole page, until the
footer.