There is a Page Setup in Word 2007. It is accessed via Page Layout | Page
Setup dialog launcher. But the more critical setting will be in the
Borders and Shading dialog (changing the Page Border setting from "Edge of
page" to "Text"), and that is found at Page Layout | Page Borders | Options.
If you have changed this setting without improvement, then either your
bottom margin is still too small or you have the page border surrounding the
header and footer. Surrounding the footer will almost always result in the
page border being in the unprintable area.
--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
"Nanlan" wrote in message
...
"Jay Freedman" wrote:
On Tue, 11 Nov 2008 15:56:02 -0800, Nanlan
wrote:
Office 2007. When composing a document & adding a border my initial
screen
shows the border completely intact. When you go to "print preview" or
actually "print" no bottom border shows. I have moved the margins, I
have
changed the options on the border selection page. I have moved the
margin
from "edge of page" to "text" & nothing I have done will show force the
border I've selected to print or show up in print preview. What is
wrong????
Where is my bottom border???? Thanks for you time!
See http://www.word.mvps.org/FAQs/Format...sDontPrint.htm
--
Regards,
Jay Freedman
Microsoft Word MVP FAQ: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup
so all may benefit.
MR JAY FREEDMAN,
Thank you for your prompt response to my question concerning the bottom
border not printing & not showing up at all in "print preview".
Unfortunately the suggestions you gave me did not correct this problem. I
have a new Toshiba Laptop (Vista & Office 2007) & a new Lexmark 4 in 1
printer. I tell you this to affirm that I do have "modern" equipment.
There
is no "page set up" as described in your email. In the older versions of
Office there was but not in this version. The solutions you described
would
work in an older version. I spent over 2 hours on the phone today with
Lexmark Technical Support discussing this difficulty. They believe this is
a
glitch that needs to be addressed by Microsoft. Do you have any further
suggestions????