View Single Post
  #1   Report Post  
Badar Munir
 
Posts: n/a
Default how to create a template table.

hi all.
I am Badar. I am stuck in a strange requirement. I need to create a table
such that the left most column is at top level in bullets (say that is 1),
then the column on the right of that column have bullet 1.1, 1.2, and so on
i.e the column on right goes one level down of the left one. Plz see the
thing below which further helps....

Col1 Col2 Col3 Col4 ... ....
1 1.1 1.1.1 1.1.1.1
1.1.1.2
1.1.1.3
1.1.2 1.1.2.1
1.1.2.2
1.2 1.2.1 1.2.1.1

and so in this manner.

Kindly pull me out of this trouble. Ur help will be higly appriciated.

Muhammad Badar Munir
Software Test Engineer.
Sabri Technologies.
1 Ranjeet Park , Mission Rd,
Lahore. Pakistan

Tel : +92 (0)42 7313431
Fax : +92 (0)42 6316382





This message contains confidential information and is intended only for the
individual named. If you are not the named addressee you should not
disseminate, distribute or copy this e-mail. Please notify the sender
immediately by e-mail if you have received this e-mail by mistake and delete
this e-mail from your system.

E-mail transmission cannot be guaranteed to be secure or error-free as
information could be intercepted, corrupted, lost, destroyed, arrive late or
incomplete, or contain viruses. The sender therefore does not accept
liability for any errors or omissions in the contents of this message which
arise as a result of e-mail transmission. If verification is required
please request a hard-copy version.