[Linda]

The Table of Contents (TOC) for an installation guide I am updating includes
rules before each Heading 1. However, the rules do not show up in the TOC if
the previous section in the document does not have a Heading 2 style applied.
Sometimes a section just doesnt have any other headings besides Heading 1,
but I need to have the rules appear in the TOC. How can I do that without
making up a section for the Heading 2 style?

I tried to recreate the TOC below. Section 5 does not have a rule because
Section 4 in the document only has the Heading 1 style applied. If Section 4
had a Heading 2, then the rule would appear. Appendix A and Appendix B do not
have rules because the previous sections do not have Heading 2 styles.

Table of Contents
__________________________________________________ _____
SECTION 1:
INTRODUCTION...................................... .................2
Document
Conventions....................................... ..................2
__________________________________________________ _____
SECTION 2:
OVERVIEW.......................................... ...................4
About The
Software.......................................... ....................4
__________________________________________________ _____
SECTION 3:
INSTALLATION...................................... .................5
Installation
Steps............................................. .....................5
__________________________________________________ _____
SECTION 4: TROUBLESHOOTING INSTALLATION PROBLEMS.........6

SECTION 5:
SUMMARY........................................... ...................7

APPENDIX A:
ACRONYMS.......................................... .................8

APPENDIX B: SYSTEM REQUIREMENTS...................................... ..9

I know this is confusing. Any advice will be appreciated.

Thanks,
Linda