[Suzanne S. Barnhill]

Alt+F9 toggles field display. Since you mentioned seeing EMBED, I suspected
you were seeing a field code, so Alt+F9 would toggle between display of
field codes and field results. If you're just seeing an empty box, make sure
that "Picture placeholders" is not checked on whatever passes for the View
tab of Tools | Options in Word 2007, probably something like this: Office
Button | Word Options | Advanced, "Show document content."

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

"Judy" wrote in message
...
Thank you very much - that gives me the spacing (if not the actual image)
which allows me to space properly. Where did you find this information? -
--
Thanks - J


"Suzanne S. Barnhill" wrote:

Have you tried pressing Alt+F9?

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

"Judy" wrote in message
...
I have a letterhead from a previous word program. When I use it in Word
7,
instead of viewing the image, it just reads imbedded image. The
spacing
is
not correct between the words "imbedded image" and the image itself.
Therefore when typing below the "imbedded image" it is difficult to
tell
how
much of the page is used and how it will print. I can see the image
when
asking for a print preview, but can't change it at that point and have
to
go
back and guess again where the typing will end up on the printed page.
suggestions on how to view the imbedded image on the page as I type?
--
Thanks - J